[Server] Cisco UCS C-series use ‘Direct Connect Mode’ , don’t need FEX

自UCS 2.2開始支援C-series (Rack-Server) 可以直連Nexus FI6xxx ,無需透過Nexus 2K series Fabric Extenders (FEX)

(注意事項)
1. C200, C210, and C250 do not support Direct Connect.
2. A maximum of 120 virtual interfaces (但透過FEX原是可以到256 virtual interfaces)
3. UCSM need 2.2 and above
4. following supported Cisco UCS C-Series servers and corresponding CIMC release versions listed in the following table
5. VIC adapters must be installed in the correct slot
6. FI ports must be configured as “server" ports
7. At least one 10-Gb SFP cable for each card. You cannot connect the card to the same FI from both the ports

(Before You Begin)
1. FI ports are configured as “server" ports
2. Cisco UCS VIC 1225 or Cisco VIC 1227 is installed in the correct slot
3. Do not mix SFP types on an uplink with FI

(Topology)
UCS-C-series-direct-mode.jpg

 

 


Reference : Cisco – Cisco UCS C-Series Server Integration with Cisco UCS Manager 2.2

發表迴響

在下方填入你的資料或按右方圖示以社群網站登入:

WordPress.com 標誌

您的留言將使用 WordPress.com 帳號。 登出 /  變更 )

Google photo

您的留言將使用 Google 帳號。 登出 /  變更 )

Twitter picture

您的留言將使用 Twitter 帳號。 登出 /  變更 )

Facebook照片

您的留言將使用 Facebook 帳號。 登出 /  變更 )

連結到 %s